OREGANO OIL VAPE KIT INSTRUCTIONS

General Information:
- This inhaler kit is renowned for its effectiveness against fungal, viral, and bacterial conditions, as well as aiding acute breathing issues.
- Consult your doctor before using these products for professional advice.
- Refer to the instruction booklet enclosed in your kit for detailed information on usage, maintenance, and servicing.

Preparation of Vaporiser:
- Fill the glass vial's outer ring (not the center hole) with a mixture of pre-mixed vegetable glycerin and oregano oil, just below the top of the inner ring.
- Replace the top cap while pressing and screwing it clockwise. Avoid over-tightening.
- Mix both oils thoroughly by tumbling the vaporiser in your hand.
- Ensure batteries are fully charged.
- Keep the vape upright and empty it when not in use for more than a day or two.

Activation and Operation:
- Press the side button of the vaporiser five times quickly to activate it; LED lights will flash.
- Deactivate by pressing the black button five times again.
- Wait for 10 minutes to allow the oils to wick into the burner chamber to prevent overheating.
- Adjust the top cap with slots to control airflow; fully open it during the initial treatment.
- Test the unit by holding down the button and blowing into the top for 3 or 4 seconds to emit vapor from the air slots.

Inhalation Procedure:
- Exhale completely before placing the vaporiser's open end in your mouth.
- Tilt your head slightly backward and slowly suck in air through the hole while pressing the on button.
- Inhale until your lungs are full, then hold your breath for ten seconds before exhaling.
- Repeat this process five times per session, up to five times per day for three days.
- Coughing may occur initially, which is normal.
- Consider adding more oregano oil for increased benefits.

Storage and Maintenance:
- Keep the oils away from sunlight and store them in a cool, dry place to maintain quality.
- Empty vape tank after use and store upright.